Please find below instruction on how to set it up:
Available from 8.0 2015-09-08 on Windows, Linux, Mac

For customers that are self-hosted i.e.they have their Standard ERP server on-premise at their site or through a 3rd party server provider.

Following is notes on how to do this:

Before Installation:
Ensure that customers IT has setup ports for “Standard ERP Service” and “Cloud Node Service”
- These can be any ports however following are recommended for consistency purposes only.
- Standard ERP Service - 1200, 1080, 1443 (or 80 or 443 if using webshop)
- Cloud node ports - 1301, 1081, 499
- These ports should be open on the firewall over TCP for incoming and outgoing traffic for the Standard ERP and Cloud Node executables.
- If customer says that they want to open the ports only to a specific IP then ask ASP what is the IP address of your cloud controller.


Installation Process:
- As per normal, customer should have Standard ERP Service installed on their server and running
- If customers server has “Anti-Virus” software running then please ask them to turn this off temporarily while cloud node setup is being done.
- Login from the client
- Make sure that in Technics>>Register>>Program Mode>>Server port, HTTP port, HTTPS port is listed correctly
- Go to Technics>>Register>>Program Mode>>Operations>>Setup Cloud Node
- Ensure that Cloud node ports, Standard ERP System ports and customer IP address details are correct and press RUN

What happens:
- First on their server a cloud node folder will be created where all of the cloud node software will be downloaded (this may take 10 to 15 minutes depending on customers internet speed)
- In your countries cloud controller - Module>>ASP>>Register>>Cloud Node an entry will be made for this customer with code ASP-<customer number>
- Once the cloud node has finished setup, following will happen:
- Client will quit (on windows); on Mac users will face a small hang for 10 seconds
- On Cloud Controller - Module>>ASP>>Register>>Remote Cloud Server>>Customers Server will be created
- On customer server, the StandardERP executable will no longer be running but instead hansa-cloudnode executable will run.

Important points:
- Going forward customers should start/stop their server using myservers website or through Support (mypages/myservers - yet to be launched)
- If they physically shutdown or re-start the server or they stop the software on their server for any reason then they should start hanse-cloud node executable. This is found inside the Cloud Node folder on the server (inside the Standard ERP server folder)

The most problems come from ports not being open, so please check that.